SIMONSWERK BANDTECHNIK

PRODUKTSELEKTOR

Serial drilling jig VARIANT VN 3700/160

for drilling of blind rivet nut M 10 with steel frames

Note

Fitting instructions

1. Position drilling jig to corresponding door part. The 3,5 mm clearance on the hinge side is considered in the jig.
2. Position stop tube for right- or left hand.
3. Pre-drill steel frame with Ø 6,5 mm, remove jig and redrill with Ø 12,1 mm.
4. Scrape out a lateral shoulder within the drilled hole, to create room for the blind rivet nut M 10.
5. Fit a blind rivet nut M 10 with blind rivet tongs M 10. Press the tongs firmly against the frame.
6. Place iron washer on frame pin and screw in until force-locked.
7. Hang door.

 

Scope of supply

2 x drilling jigs
1 x square connecting rod
2 x stops
1 x stop tube
1 x drill bit Ø 6,5 mm
1 x drill bit Ø 12,1 mm
1 x fitting instruction

 

Note

Also available as plug-on drilling jig VN 3700/160.

Item versions

000-without

Serial drilling jig VARIANT VN 3700/160 for drilling of blind rivet nut M 10 with steel frames - - Simonswerk GmbH
Packing unit pack of 1
DIN DIN right and left hand
Item No. 5 250820 0 00001
EAN 4015471020255

Advice

Downloads

Product information

Free software and download notes