SIMONSWERK BANDTECHNIK

Serial jig VARIANT V 3607

for drilling and routing of VARIANT V 3607

Note

Fitting instructions

1. Clamp series jig to frame. The 3,5 mm clearance on the hinge side is considered in the drilling jig.

2. Drill holes for frame parts with Ø 7,2 mm drill bit.

3. Rout slots with Ø 12,0 mm cutter (Ø 30,0 mm collar ring).

4. Insert clamping blocks.

5. Insert frame parts and fasten with Allen screw.

 

Scope of supply

2 x drilling/routing jigs

1 x square connecting rod

2 x stops

1 x drill bit Ø 7,2 mm

1 x set ring

1 x fitting instruction

 

Note

Please indicate frame-line width when ordering drilling jig. This series jig is pre-set to standard measurements according to German Standard 18101.

To mount VN 3938/160, VN 3938/160 FD, please request special jigs.

Item versions

without (000)

Serial jig VARIANT V 3607 for drilling and routing of VARIANT V 3607 - - Simonswerk GmbH
Packing unit pack of 1
DIN DIN right and left hand
Item No. 5 250826 0 00001
EAN 4015471020170

Advice

Downloads

Product information

Free software and download notes